Injection moulding machine Baby plast 6/10 P-CE

Device is for:

  • Fully hydraulic injection moulding machine for injection of very small parts.
  • Clamping force – 62 kN
  • Min./Max. mould height – 70/180 mm
  • Max. mould dimensions – 75 x 75 mm
  • Piston diameter – 10 mm
  • Theoretical injection volume– 4 cm3

contact person:

doc. Ing. Tomáš Sedláček, Ph.D.

+420 57 603 8012 A416
+420 724 434 581
This email address is being protected from spambots. You need JavaScript enabled to view it.
 research

INJECTION MOULDING

Injection moulding machine Baby plast 6/10 P-CE

Injection moulding machine Baby plast 6/10 P-CE

Injection moulding machine Mitsubishi 180MET III-15h

Injection moulding machine Mitsubishi 180MET III-15h

Equipment for preparation of nanofibers

Equipment for preparation of nanofibers

Hot drying air silo

Hot drying air silo

Moulds for test specimes

Moulds for test specimes

Set of sintering ovens for PIM

Set of sintering ovens for PIM

Mould for preparation of test specimens evaluating of separation of highly filled polymer systems

Mould for preparation of test specimens evaluating of separation of highly filled polymer systems

Electric bi-component injection moulding machine (FB140T)

Electric bi-component injection moulding machine (FB140T)

Contacts

Management


This email address is being protected from spambots. You need JavaScript enabled to view it.

Copyright 2017 © Centrum polymerních systémů. Všechna práva vyhrazena
Dodavatel webu: Digitální #agentura Weboo